What do our operators need to pay attention to when operating the automatic assembly equipment in Wuhan? Many new colleagues are not very clear, so please see the use of the automatic assembly equipment we have below.
1. When the automatic assembly equipment is being cleaned up, the operator should always observe the ammeters of the 6 shot blasters. If it is higher than 25, adjust the amount of sand and try to control it below 22. If the inverter is working, the inverter should be stopped. , To refer to the description of the failure description of the number of instructions to deal with.
2. Set a high frequency for the mechanical equipment. This frequency corresponds to the rated speed of the automatic assembly equipment and can reach about 3000 rpm. If you want to change the speed, you can turn the knob on the frequency converter, and the frequency value displayed above is decreasing. It's not that the speed is decreasing.
　　 Third, when operating the left and right rollers of the automatic assembly equipment, the knob should be at low speed and the switch should be in the power-off state, then press the start button on the console, and then turn on the switch on the controller. At this time, turn the knob to adjust the speed. In the event of a power failure, first turn the knob to the low position, then turn off the switch on the controller, and then press the stop button on the console.
　　 Fourth, the automatic assembly equipment is equipped with an emergency stop button and a key switch if any one of them is turned off, then the whole line will stop.
　　 Fifth, when the automatic assembly equipment is in production, it needs to be started in order, otherwise it will not work. 　　 Six, if one of the parts fails during operation, the latter will also stop